Keep Your Ember RV Adventure-Ready: Overland Maintenance Checklist

At Ember, we know that your RV is more than just a vehicle, it’s your ticket to adventure. Whether you’re exploring with an E-Series or venturing off-grid with an Overland Series, regular maintenance is the best way to keep your RV safe, reliable, and ready for wherever the road takes you.

Here’s a simple guide, broken down into timeframes to help you stay on top of your RV care.

Overland Series Maintenance Checklist

Every Trip

• Check batteries; service if needed
• Confirm entry door latches and locks function properly
• Drain plumbing system holding tanks
• Check operation of detectors – R&R batteries every 6 months if equipped
• Test and confirm egress (exit) windows function properly

• Check slide roof for debris and clear
• Check and clean all seals
• Clean away dust and grime on solar panels
• Check wheel lugs for proper torque
• Check tire inflation pressure (see tire label for pressures)

Monthly

• Make sure appliance burner tubes/vents are clean/unobstructed
• Confirm baggage doors seal tight and are not leaking
• Grease the worm gear on front jack
• Check hitch/coupler bolt torque
• Test and confirm egress (exit) windows function properly

Every 3 Months

• Check and service batteries
• Test all GFI outlets
• Wash exterior with warm water and mild detergent
• Inspect exterior sealant for voids/gaps/cracks and reseal
• Check plumbing hoses, fittings pipes for leaks; tighten as required
• Inspect roof sealant for voids/gaps/cracks and reseal

• Check slide roof for debris and clear
• Check and clean all seals
• Check wheel lugs for proper torque
• Inspect tire for wear/damage/etc.
• Check tire inflation pressure (see tire label for pressures)

Every 6 Months

• Lube entry door hinges w/light oil or WD40 (or comparable)
• Adjust screen door latch on entry door
• Clean and lubricate entry steps (lithium spray)
• Apply non-abrasive wax on exterior (except on decals)
• Clean roof with water and mild detergent

• Check operation of detectors – R&R batteries every 6 months if equipped
• Test and check fire extinguisher for proper charge

Annually

• Check appliance settings and adjust per manufacturer’s guide
• Clean and sanitize appliances
• Clean and lube awning moving parts w/ WD40
• Check axle/suspension torque- all bolts (see axle MFG guide for specs)

• Check brake/wheel hubs amp draw/shoe wear/adjustment (see MFG specs)
• Lube bearings (as needed)
• Test all GFI outlets
• Service generator (if equipped) per MFG manual
• Check underbelly/frame for damage, loose wires, debris, etc. and clean
• Check for damage and wear – clean & lubricate (grease)
• Have LP system tested for leaks by qualified dealer
• Have LP system pressure and regulator settings checked by dealer
• Check plumbing hoses, fittings, pipes for leaks – tighten as req.
• Lubricate termination gate valve cables (WD40 or lithium grease)
• Winterize system (cold weather locations)
• Clean and lube roof vent mechanisms w/ light oil
• Test and check fire extinguisher for proper charge
• Test and confirm egress (exit) windows function properly
• Check slide roof for debris and clear
• Check and clean all seals

Before/After Storage

• Check appliance settings and adjust per manufacturer’s guide
• Make sure appliance burner tubes/vents are clean/unobstructed
• Clean and sanitize appliances
• Wash awning(s) with warm water and mild detergent
• Clean & lube awning moving parts w/WD40
• Check U-bolts, springs & hangers for damage
• Check torque – all bolts (see axle MFG guide for specs)
• Apply grease via the Zerk fitting as needed on axle/suspension
• Confirm that baggage doors seal tight and are NOT leaking
• Spray baggage door lock tumblers with graphite
• Charge to 100% and disconnect from any loads
• Check and service batteries
• Test all GFI outlets
• Service generator (if equipped) per MFG manual
• Make sure entry door latches and locks function properly
• Lube hinges w/light oil or WD40 (or comparable)
• Adjust screen door latch
• Clean and lubricate entry steps (lithium spray)
• Wash exterior with warm water and mild detergent
• Inspect exterior moldings sealant for voids/gaps/cracks and reseal
• Check underbelly/frame for damage, loose wires, debris, etc. and clean
• Check frame for rust and touch up if necessary
• Check hitch/coupler for damage and wear – clean & lubricate (grease)
• Check plumbing hoses, fittings, pipes for leaks – tighten as req.
• Lubricate termination gate valve cables (WD40 or lithium grease)
• Drain holding tanks
• Inspect roof for sealant voids/gaps/cracks and reseal
• Clean roof with water and mild detergent
• Clean and lube roof vent mechanisms w/light oil
• Check operation of detectors – R&R batteries every 6 months
• if equipped
• Check slide roof for debris and clear
• Check and clean all seals
• Check wheel lugs for proper torque
• Inspect tire for wear/damage/etc.
• Check tire inflation pressure (see tire label for pressures)

Pro Tip: These lists are the minimum requirements. If you camp in extreme heat, cold, or off-road often, you’ll want to check things more frequently. A little preventative care goes a long way in protecting your investment — and your adventures! Download a printable version of this checklist here or find it in your Ember RV Owner’s Manual.

Download a printable version of the checklist here.